Power-Elec-6 - LoRaWAN and Modbus multi-circuit power meter
Multi-circuit energy meter
Recommended to meet the requirements of the ISO 50001 standards, the Power-Elec unit optimizes the deployment of electricity sub-metering, for both new installations and retrofits.
With its 6 RJ45 inputs, the power meter can measure 6 three-phase circuits or 18 single-phase circuits (mix possible), with an accuracy of 1% for active power, voltage, current and power factor.
It can send its data through LoRaWAN wireless protocol or by wired protocols such as Modbus TCP, Modbus RS485 or BACnet IP.
Beyond basic energy metering
The Power-Elec-6 meter also computes advanced measurements such as:
- Electrical faults and risks: micro-outages, voltage sag and swell, cable overheating, voltage and power imbalance, harmonic distortion rate.
- Operating condition monitoring: operating hours and number of cycles, overload and efficiency-loss detection.
These measurements are available in Expert mode.
Current transformers and Rogowski coils
Opening current transformers and Rogowski coils allow current to be measured by clipping around cables. They are therefore ideal for retrofitting.
They are assembled in kits of 3 and are connected to the Power-Elec meter via an RJ45 cable. Several sizes and ratings are available to suit a wide range of configurationss.
Transformer kits are supplied with a 2.5 m RJ45 cable and are available with a DIN rail mounting adapter (except flexible rogowski kits)
Because the CTs are openable, they adapt to all cables and can be installed in cabinets with limited space.
Easy installation
Space-saving: 6 DIN modules vs. 24 for 6 three-phase modular meters.
Time-saving: a single voltage connection for measuring up to 6 feeders.
CTs or open coils: no need to remove the cables from the circuit breaker being measured.
Easy configuration
Configuration from a Laptop or a smartphone via Wi-Fi
Simple, user-friendly interface for quick configuration of all connector parameters.
The PE6 meter displays Fresnel diagrams to diagnose CTs and Rogowski coils installation errors. It is also possible to reverse the direction of the CTs to compensate for an error.
LoRa and other protocols can be activated in a single click.
Easy visualiszation
Once configured, the PE6 shows all the measured data on its Wi-Fi interface (current, voltage, active power, reactive power, power factor...).
This interface can be displayed using the PE-TAB, transforming the Power-Elec-6 into a genuine real-time measurement unit.
Our products are stored and shipped within 24 hours of receiving the order. Please feel free to contact us to get a quick and free quote!